GE DISHWASHER CONFIGURED UI BOARD – WD21X31909

This is a genuine OEM part that works for some models of GE, and Hotpoint models. Step 1: Unplug the power cord for the dishwasher.

Step 2: Open the dishwasher door and remove all racks, utensils, and other items.

Step 3: Locate the GE WD21X31909 Configured UI Board inside the control panel.

Step 4: Disconnect any connected wires to the board.

Step 5: Remove the mounting screws that secure the board in place.

Step 6: Slide the board out of the control panel.

Step 7: Install the new board in the same position as the previous one.

Step 8: Connect all wires back to the corresponding locations on the new board.

Step 9: Secure the board in place with the mounting screws.

Step 10: Once the board is in place and secured, you can test it to make sure it is functional.

Step 11: Plug the power cord back in and turn the dishwasher on to make sure it is working.

Step 12: Enjoy your newly repaired dishwasher!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. No more associated models for this part.