GE DISHWASHER SPRAY ARM WELD – WD22X10055

Spray arm weld works with some GE, and Hotpoint models of dishwashers. 1. Unplug your dishwasher and empty any water or dishes inside.

2. Using a Phillips head screwdriver, remove the two screws on the outside of the lower access panel at the bottom center of the dishwasher.

3. Pull down the access panel to loosen it, then slide it away from the dishwasher.

4. Locate the spray arm mount in the center of the dishwasher. Its round shape and distinct ridges can identify this.

5. Use a pair of pliers to disconnect the hose clamps for both the upper and lower spray arms. If there is corrosion around the clamp area, you may need to scrape it away before easily removing them.

6. Carefully remove the upper and lower spray arms.

7. Remove the mounting clip by carefully prying it off with a flathead screwdriver.

8. Remove the defective spray arm weld (WD22X10055 GE Dishwasher Spray Arm Weld) and replace it with a new one. Make sure it is securely fastened to the mounting clip.

9. Reassemble the mounting clip and replace the upper and lower spray arms.

10. Reconnect the hose clamps for both spray arms.

11. Replace the lower access panel and secure it with the two Phillips head screws.

12. Plug in your dishwasher and test it out.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. Search GHDA350N00BB GHDA350N00WW GHDA350N10BB GHDA350N10WW GHDA350N20BB GHDA356N00SS GHDA356N10SS GHDA356N20SS GSD3300N00BB GSD3300N00CC GSD3300N10BB GSD3300N10CC GSD3300N10WW GSD3300N20BB GSD3300N20CC GSD3300R00BB GSD3300R00CC GSD3300R00WW GSD3300R15BB GSD3300R15CC GSD3300R15WW GSD3300R20BB GSD3300R20CC GSD3300R20WW GSD3340D35MB GSD3360N00SS GSD3360N10SS GSD3360N20SS GSD3360R00SS GSD3360R15SS GSD3300D35CC GSD4060D45SS HDA3600H45BB GSD3300D45BB GSD3300D45CC GSD3340D45SA HDA3600H45WW GSD3300V00BB GSD3300V00CC GSD3300V00WW 1 2 3 4 5