FRIGIDAIRE 4″ DIA. DRYER 90 DEGREE CLOSE VENT ELBOW – 5305514872

The Electrolux Frigidaire 5305514872 4″ Dia. Dryer 90 Degree Close Vent Elbow offers an easy-to-install solution for your dryer venting needs. Constructed of high-quality steel, it has a smooth interior and exterior to ensure a secure seal and prevent lint build-up. The elbow bends the dryer vent at a 90 degree angle to help save on space and is designed to fit most standard 4” diameter dryer vent systems. It’s pre-drilled with 1/8” holes for easy mounting and comes backed by a limited lifetime warranty. Get a secure seal and save on space with the Electrolux Frigidaire 5305514872 4″ Dia. Dryer 90 Degree Close Vent Elbow. We’re your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs! Instructions for Replacing a 5305514872 4″ Dia. Dryer 90 Degree Close Vent Elbow by Electrolux Frigidaire

1. Turn off the power to the dryer. Unplug it from the electrical socket and/or switch off the circuit breaker.

2. Remove the existing vent elbow from the back of the dryer. Begin by unscrewing the screws that secure the elbow to the back of the dryer.

3. Disconnect the end of the vent hose that is connected to the elbow by loosening the clamps holding the hose in place. Pull the vent hose off of the elbow.

4. Install the new vent elbow. Start by inserting the new elbow on to the end of the vent hose. Make sure to firmly press the elbow onto the vent hose.

5. Secure the elbow to the back of the dryer with the screws that were removed. After tightening the screws, test the connection to make sure it’s secure.

6. Turn the circuit breaker or plug the dryer back into the electrical outlet and test the dryer to ensure the vent elbow replacement was successful.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. No more associated models for this part.