GE 14″ UNIVERSAL HOUSEHOLD UNDER SINK WATER FILTER – FXUTC

GE General Electric Hotpoint 14″ Universal Household Under Sink Water Filter FXUTCThe FXUTC GE Smart Water filter is a single-stage undersink water filter that is compatible with any brand of water filtration system that uses 9 3/4 inch x 2 1/2 inch filters. It filters out the less impurities than the FXULC or the FXUVC, but has a longer filter life .. Compatible with the following: FXUTC GN1S15 GN1S15CBL GN1S20C GX1S01C GX1S04C GX1S15 GX1S15CWe are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs. Step 1: Turn off the water supply to your sink. This is typically located in the basement, or under your kitchen or bathroom sink.

Step 2: Disconnect the supply line from the old filter by unscrewing the tubing from the filter head. Be sure to make note of the direction it was connected to the filter head as this will assist in the installation of the new filter.

Step 3: Unscrew the mounting bracket located at the bottom of the filter housing and remove the old filter.

Step 4: Take the new FXUTC GE 14″ Universal Household Under Sink Water Filter and install it in the mounting bracket. Secure the filter using the same screws you used to remove the old filter.

Step 5: Place the supply line back on the filter head. Make sure to tie the tubing off if necessary and secure it in place with the included clamps.

Step 6: Re-connect the water supply to the sink.

Step 7: Turn on the water supply to make sure that everything is connected properly and that there are no leaks.

Step 8: Flush the filter for up to 5 minutes to clear out any dust or debris that may be left over from the filter’s shipping process.

Step 9: Test the water filter for function.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. Search GX1S15C