SAMSUNG WASHER PULSATOR CAP – DC66-00887A

Pulsator Cap works with some models of Samsung Washers Replacing the DC66-00887A Samsung Washer Pulsator Cap: A Step-by-Step Guide

Are you looking to replace your Samsung Washer’s DC66-00887A Pulsator Cap? Follow this DIY guide to learn how to do it on your own in a few simple steps.

Step 1: Preparing the Washer

Before you get started, make sure the power to the washer is turned off. You can do this by unplugging the power cord from the outlet.

Next, shut off the water supply and disconnect the hoses from the back of the washer. The hoses should be disconnected from both the hot and cold water inlet valves.

Step 2: Removing the Old Pulsator Cap

Locate the pulsator cap, which should be located in the center of the washer tub. There will be four screws holding the cap in place.

Remove the screws and then gently lift the pulsator cap up out of the washer.

Step 3: Installing the New Pulsator Cap

Place the new pulsator cap into the opening in the washer tub. Make sure the cap is properly aligned so that all four screws can be reinserted.

Secure the cap in place by screwing in the four screws.

Step 4: Reconnect Hoses and Power Cord

Reattach the water supply hoses to the washer, making sure they are connected to the hot and cold water valves.

Finally, plug the power cord back into the outlet.

You’re now ready to use your washer again. It’s as simple as that!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. Search WA45K7600AW-A2-00 WA50K8600AV-A2-00 WA50K8600AW-A2-00 WA45K7600AW/A2 WA50K8600AV/A2 WA50K8600AW/A2