WHIRLPOOL 4″ DIA. DRYER CLOSE ALUMINUM VENT ELBOW – 4396006RW

Dryer Close Aluminum Vent Elbow, 4 in. By Whirlpool Maytag 4396006RWThis DuraSafe™ Close Elbow effectively turns 90 degrees within 4-1/2″. It features snap-lock fittings and rotating collars. It is an ideal product for limited space installationsWe are a Factory Authorized Parts Distributor for Whirlpool Maytag. Trust us for all of your Whirlpool Maytag appliance parts and accessories needs. Step-by-Step DIY Instructions for Replacing a Whirlpool 4″ Dia. Dryer Close Aluminum Vent Elbow 4396006RW

1. Unplug the dryer and power off any gas lines connected to it.

2. Move the dryer away from the wall and pull the vent duct out of the wall.

3. Loosen the screws or clamps on the old elbow and remove it.

4. Set the new vent elbow in place and secure with the same screws or clamps.

5. Connect the new elbow to the vent duct and secure it with tape or other appropriate connectors.

6. Plug in the dryer and turn the power back on to check for proper operation.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. SearchThe following parts are replaced by this product 4396006 10131 Search WED5100HC0 WED5100HW0 WED6120HC0 WED6120HW0 WGD5100HC0 WGD5100HW0 YWED5100HC0 YWED5100HW0 YWED6120HC0 YWED6120HW0 WED7120HC0 WED7120HW0 WED8120HC0 WED8120HW0 WGD7120HC0 WGD7120HW0 WGD8120HC0 WGD8120HW0 YWED7120HC0 WED5100HC1 WED5100HW1 WED6120HC1 WED6120HW1 YWED6120HC1 YWED6120HW1 YWED7120HC1 YWED5100HC1 YWED5100HW1 WGD8127LW0 WED8127LW0 WGD8127LC0 WED8127LC0 WGD7120HC1 WGD7120HW1 WED7120HW1 WED7120HC1 MGD7230HC1 WED5100HW2 MGD7230HW1 WED8127LW1 1 2 3