WHIRLPOOL AGITATOR CAM KIT – 285748

This Whirlpool Agitator Cam Kit (285748) provides effective performance and reliable quality to help prolong the life of your washing machine. This kit includes an agitator directional cams and cap seals so you can easily replace worn-out components and keep your washer running smoothly. The kit is designed to replace direct drive washers manufactured by Whirlpool and other brands, and it’s compatible with the following models: WTW6700TW0, WTW6200SW2, WTW7000DT2, WTW7000DW2, and more. With the 285748 kit, you can get back to completing your laundry duties with minimal fuss. We’re your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs! DIY Instructions for Replacing the 285748 Whirlpool Agitator Cam Kit

Tools needed: Flathead and Philips head screwdrivers, pliers, and a replacement 285748 Whirlpool Agitator Cam Kit.

Step 1: Unplug the washer from the wall. Make sure it is completely disconnected from power.

Step 2: Turn off the water supply to the washer. You will need to locate the shut-off valve and turn it off before continuing.

Step 3: Remove the agitator cap. This is typically located on top of the agitator or in the center of the agitator. Gently use a flathead screwdriver to pry off the cap.

Step 4: Remove the screws that are securing the agitator to the outer tub. Use a Phillips head screwdriver to remove the screws and then set them aside.

Step 5: Slide the agitator off of the outer tub. Be careful not to damage the rubber seal.

Step 6: Locate the cam assembly, which is usually located near the bottom of the agitator.

Step 7: Use a pair of pliers to loosen and remove the retaining clip that holds the cam assembly.

Step 8: Disconnect the wiring from the cam assembly and then remove the old assembly.

Step 9: Install the new 285748 Whirlpool Agitator Cam Kit using the same technique used to remove the old cam assembly.

Step 10: Reconnect the wiring to the new assembly.

Step 11: Secure the cam assembly with the retaining clip and tighten with a pair of pliers.

Step 12: Slide the agitator back on to the outer tub and secure with the screws removed earlier.

Step 13: Finally, replace the agitator cap and make sure it is securely in place.

Step 14: Once all the steps are complete, plug the washer back into the wall and turn on the water supply. You should now have a properly functioning agitator.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. SearchThe following parts are replaced by this product 3347085 3351000 3363662 No more associated models for this part.