WHIRLPOOL LINT SCREEN FILTER – W10120998

Whirlpool – Sears Kenmore – KitchAid – Roper Dryer Lint Filter Screen – White – W10120998This lint screen fits most 27″ (cabinet width measure) Whirlpool-built dryers under the brand names of Whirlpool, Whirlpool Gold, Kenmore, Kenmore Elite, Catalyst, Duet, Duet HT, KitchenAid, KitchenAid Ensemble, among others.. This is the lint screen located inside the dryer, just as you open the dryer door. It says “Clean Before Each Load” right on it, and it is white in color.Measurements (which are approximate) are: 12-1/8″ Wide, 10-5/8″ High (at the highest point). We are an Authorized Parts Distributor for Whirlpool call us today for all of your Whirlpool appliance parts. Replacing the W10120998 Whirlpool Lint Screen Filter

Tools Needed:
* Flathead Screwdriver
* Phillips head screwdriver

Instructions:
1. Unplug your dryer from the wall.
2. Pull the lint filter out from the top of the dryer and lay it flat on a table or countertop.
3. Unscrew the screws holding the lint filter in place using a flathead or Phillips head screwdriver.
4. Remove the lint filter and discard it.
5. Insert the new W10120998 Whirlpool lint screen filter into the opening.
6. Secure the new lint filter in place by replacing the screws you removed earlier.
7. Replace the lint filter in the top of the dryer.
8. Plug the dryer back into the wall outlet and turn it on.

Your new W10120998 Whirlpool lint screen filter is now installed and ready to use!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. SearchThe following parts are replaced by this product 3390721 8066170 8572268 W10049370 W10178353 DE0998 No more associated models for this part.