WHIRLPOOL REFRIGERATOR ICE AND WATER FILTER 5 (PINK) – EDR5RXD1

Water filter 5 works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of fridges. 1. Turn off the ice maker in your Whirlpool refrigerator by pressing the switch located inside the refrigerator near the top of the refrigerator door.

2. Locate the water filter compartment in the back of your refrigerator. It will be either on the bottom of the refrigerator, behind the kick plate panel, or up in the top right hand corner of the refrigerator, depending on the model.

3. Twist and remove the old filter to access the O-rings.

4. Remove and discard the O-ring from the filter housing.

5. Install the new EDR5RXD1 Whirlpool Refrigerator Water Filter 5.

6. Put the O-ring back into the filter house, ensuring it’s sealed properly.

7. Turn the new filter to the right to lock it into place.

8. Restore power to your ice maker and wait an hour for it to produce ice.

9. Run several gallons of water through the filter to flush out any air bubbles or debris.

10. Enjoy clean, filtered water!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. SearchThe following parts are replaced by this product 4392857 4392922 9902 2203220 2200203 4396164 4396163 4396508 9908 4396510 4396547 4396548 9010 4396918 4396508BULK 1 2 No more associated models for this part.