WHIRLPOOL WASHER WATER INLET FILL VALVE – 205613

The 205613 Whirlpool Washer Water Inlet Fill Valve is an OEM replacement part designed to bring your washer back to life! This quality part is designed to replace the factory fill valve to provide a hassle-free installation experience. With reliable, long-lasting performance, you can rest assured that your washer will deliver the results you need. The robust design and durable construction ensure a tight seal and dependable performance. Get the job done right with the 205613 Whirlpool Washer Water Inlet Fill Valve! We’re your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs! How to Replace the 205613 Whirlpool Washer Water Inlet Fill Valve

Replacing the 205613 Whirlpool Washer Water Inlet Fill Valve is a simple do-it-yourself repair. With the right tools and supplies, you can get the job done in no time. Here’s what you need to know to replace the water inlet fill valve.

Tools & Supplies Needed

• New 205613 Whirlpool Washer Water Inlet Fill Valve

• Phillips head screwdriver

• Wrench or pliers

• Masking or electrical tape

• Small bucket or container

Instructions

1. Shut off water supply to your washer. Find the shut off valves behind the washer, usually underneath the sink. Turn them off clockwise.

2. Turn on the hot and cold water faucets to relieve water pressure on the lines and drain any remaining water out of the washer.

3. Disconnect the hot and cold water hoses from the back of the washing machine.

4. Use the Phillips head screwdriver to remove the screws from the clips holding the old water inlet fill valve in place.

5. Pull the old valve out of the washing machine.

6. Place masking or electrical tape around the threads of the new 205613 Whirlpool Washer Water Inlet Fill Valve to ensure it doesn’t leak.

7. Place the new fill valve into the washer and secure it with the clips.

8. Use a wrench or pliers to tighten the nuts that secure the new valve to the washer.

9. Connect the hot and cold water hoses to the back of the washing machine.

10. Turn on the water supply to the washer.

11. Test the new water inlet fill valve by running a cycle through the washer.

12. Clean up any excess water or debris left behind during the installation.

Congratulations! You have successfully replaced the 205613 Whirlpool Washer Water Inlet Fill Valve.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. Search A104 A105 A110 A112 A180 A181 A182 A183 A190 A1910 A209 A209S A210 A210S A211 A211S A212 A212S A282 A283 A284 A305 A308 A308S A310 A310S A312 A312S A382 A390 A3910 A410 A412 A482 A484 A490 A4910 A5000 A503 A506 1 2 3 4 5