Variable speed drain pump assembly works with some GE, Hotpoint, and RCA models of dishwashers. DIY Steps to Replace your GE WD26X25104 Variable Drain Pump Kit <\/p>\n
1. Disconnect the power to the appliance by unplugging it or flipping the circuit breaker in the breaker box.<\/p>\n
2. Remove the access panel from the back of the appliance. For some models, this may require removal of a few screws.<\/p>\n
3. Locate the drain pump assembly. This should be located near the bottom of the appliance and is often held in place by two screws.<\/p>\n
4. Unscrew the two screws and remove the old pump assembly.<\/p>\n
5. With the old assembly removed, you can now inspect the hoses and tubing to check for any signs of damage or corrosion. If any part appears damaged or corroded, it should be replaced before the new drain pump assembly is installed.<\/p>\n
6. Take the new drain pump assembly and connect the inlet and outlet tubes to the correct fitting on the pump.<\/p>\n
7. Secure the new assembly in place with the two screws and replace the access panel.<\/p>\n
8. Reconnect the power to the appliance and test the new drain pump assembly.<\/p>\n
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. Search PDT855SBL3TS CDT866P3M4D1 CDT866P4M4W2 PDT845SBL2TS PDT845SFL3DS PDT845SMJ2ES PDT845SSJ0SS PDT846SSJ0SS PDT846SSJ2SS PDT855SBL2TS CDT866P2M4S1 PDT855SIJ2II PDT855SMJ2ES PDT855SSJ0SS ZDT975SIJ0II ZDT975SIJ2II ZDT975SPJ0SS ZDT975SPJ2SS ZDT975SSJ0SS ZDT975SSJ2SS PDT855SFL3DS PDT855SIJ0II PDT855SMJ0ES ZDT915SPJ0SS ZDT915SSJ0SS ZDT915SIJ0II PDT845SSJ2SS PDT846SMJ0ES PDT846SMJ2ES PDT855SSJ2SS PDT845SMJ0ES PDT845SBL3TS CDT865SSJ2SS ZDT915SIJ2II CDT865SMJ2DS ZDT915SPJ2SS ZDT915SSJ2SS CDT865SMJ0DS CDT865SSJ0SS<\/p>\n","protected":false},"excerpt":{"rendered":"