GE General Electric RCA Hotpoint Sears Kenmore Clothes Dryer CONVERSION KIT NAT. TO LP WE25X217We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs. Step 1: Prepare the LP Conversion Kit
Before starting the conversion process, familiarize yourself with all the components of the GE Dryer Conversion Kit NAT. to LP. Make sure you have all the parts and any tools necessary for the conversion. <\/p>\n
Step 2: Disconnect the Natural Gas Line
Disconnect the natural gas line from the dryer by loosening the nuts and turning them counterclockwise. Unplug the dryer\u2019s power cord before disconnecting any gas hose. <\/p>\n
Step 3: Install the LP Gas Hose
Securely connect the LP gas hose using the nuts provided in the conversion kit. Make sure the connections are tight and secure.<\/p>\n
Step 4: Connect the Pressure Regulator
Connect the pressure regulator to the regulator on the wall. Measure and cut the hose to the desired length, then slide the clamp over the end. Make sure to tighten the clamps securely. <\/p>\n
Step 5: Mount the LP Convertor Kit
Mount the LP convertor kit in its original position. Reattach the screws that were used to remove the unit and make sure they are properly secured. <\/p>\n
Step 6: Reconnect the Hoses
Reconnect the hoses connected to the LP convertor kit. Make sure the connections are secure and make sure the valves are open. Be careful not to over-tighten the connections as this may cause damage.<\/p>\n
Step 7: Test the Conversion
Turn on the dryer and check for any gas leaks. If there are none, your conversion is complete.<\/p>\n
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available. Search GFDS355GL1BB GFDS350GL0WW GFDS355GL1MV GFDS355GL1MS GFDS355GL1MG GFDN240GL0WW GFDS350GL1WW GFDN245GL1MS GFDN245GL1MG GFDN245GL1BB GFDN240GL1WW<\/p>\n","protected":false},"excerpt":{"rendered":"